Maxus MXS21003 Owner's Manual download pdf (Page 17)

before performing Adjustment procedures, plAce the “sAfety”

in the on sAfe position. open the Action And mAke certAin your

shotgun is completely unloAded. keep the muZZle pointed in A

sAfe direction. fAilure to follow these wArnings could result

in serious injury or deAth.

INSTALLING A SPACER

1 Use a #2 cross tip or Phillips screwdriver to remove the recoil pad

at the end of the buttstock (Figure 20). Place a small amount of

petroleum jelly on the screw access slits on the top and bottom of

the rear of the buttstock to prevent damaging the recoil pad. Insert

the screwdriver into each of the two access holes. Make certain the

tip of the screwdriver engages the head of the screw. Turn the

screw counterclockwise until the screw is completely loose from

the stock. When both screws are free, remove the recoil pad.

2 Add or subtract spacers to fit your firearm to your specifications

(Figure 21). After making an adjustment hold the shotgun to your

shoulder to determine if the new length feels comfortable.

Remember to always keep the muzzle pointed in a safe direction,

with the “safety” in the on safe position and make certain the

shotgun is completely unloaded.

CHOKE TUBE INSTALLATION

1 Place the “safety” in the on safe

position. Always make sure the

shotgun is completely unloaded.

Always keep the muzzle pointed

in a safe direction.

2 Before installing a tube, check

the internal choke tube threads

in the muzzle, as well as the

threads on the choke tube to be

sure they are clean. Lightly oil

the threads with a high-quality,

lightweight gun oil.

3 Using your fingers, screw the appropriate tube into the muzzle of

the barrel, tapered end first, notched end outward. When it is

finger-tight, use the choke tube wrench to firmly seat the tube.

NOTICE! the choke tube should be periodicAlly checked to

Assure thAt it is tight And firmly seAted. before checking,

follow All choke tube removAl And instAllAtion sAfety

guidelines previously outlined.

ADJUSTING LENGTH OF PULL

The buttstock can be adjusted for length of pull by adding or

removing spacers (available separately) to the rear of the stock. Each

spacer extends length of pull ¼" and a maximum of three spacers can

be added with the screws provided to extend length of pull ¾". With

longer screws (not provided), more than three spacers can be added to

further extend length of pull.

Spacers can be ordered through your Browning dealer or by calling

our Customer Service Department at (800) 322-4626.

figure 20

Insert a screwdriver into the holes in the

recoil pad.

figure 21

Install or remove stock spacers to achieve

correct length of pull.

figure 19

Use the choke tube wrench to change

choke tubes.

08-121-BFA_Maxus OM.indd 30-31 6/22/09 2:59:58 PM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Comments to this Manuals

No comments

Maxus MXS21003 Owner's Manual Page 17

Comments to this Manuals