Maxus MXS21003 Owner's Manual download pdf (Page 19)

3 Remove the stock insert to

access the stock bolt nut

(Figure 23).

4 Use a ½" socket wrench to

remove the two stock bolt

nuts and stock bolt washer.

(Figure 24).

5 Completely remove the

buttstock from the receiver,

along with the existing shim,

and install the shim you have

selected (Figure 25). Make

certain you have the proper

shim installed and in position

before reattaching the buttstock

and recoil pad.

6 When you are satisfied with

the fit, reattach the buttstock

to the receiver with the washer

and the nuts.

7 Snug the nuts down with

the socket wrench, do not

overtighten.

8 Reinstall the stock insert.

9 Reinstall the recoil pad with care,

so as not to scratch or mar the

finish of the stock.

EXTRA BARRELS

before instAlling An Accessory bArrel on your shotgun, reAd

the following guidelines to ensure the bArrel/shotgun

combinAtion is sAfe. plAce the “sAfety” in the on sAfe position.

open the Action And mAke certAin your shotgun is completely

unloAded. keep the muZZle pointed in A sAfe direction. fAilure

to follow these wArnings could result in serious injury

or deAth.

The versatility of your new shotgun can be extended with an extra

barrel. Maxus shotgun barrels are interchangeable within a given

gauge and chamber length. No special fitting is required. However,

some important restrictions must be observed:

• Neveruseabarrelwitha3½"chamberonashotgundesignedfor

barrels with a 3" chamber.

• Neveruseabarrelwitha3"chamberonashotgundesignedfor

barrels with a 3½" chamber.

• Neveruseanyotherbarrelfromanyothermanufactureronyour

shotgun. Some other brands may seem similar, but the barrels are

not interchangeable.

• NeveruseabarrelfromanyotherBrowningshotgun.

CLEANING AND MAINTENANCE SUGGESTIONS

NOTICE! pleAse tAke note of the following informAtion before

cleAning your fireArm.

CLEANING PARTS WITH SPECIAL FINISHES

Be especially careful when cleaning firearms with camouflage,

Dura-Touch

Armor Coating and other special finishes. Always

prevent these surfaces from coming in contact with cleaning solvents,

barrel scrubbers and other strong chemicals. It is preferable to clean

these surfaces with a lightweight gun oil containing no solvents or

figure 23

Remove the stock insert.

figure 24

Use a socket wrench to remove the stock bolt.

figure 25

Install the shim between the stock and receiver.

08-121-BFA_Maxus OM.indd 34-35 6/22/09 2:59:59 PM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Comments to this Manuals

No comments

Maxus MXS21003 Owner's Manual Page 19

Comments to this Manuals