Maxus MXS21003 Owner's Manual download pdf (Page 9)

1 Lock the bolt rearward by pulling the operating handle fully to

the rear.

NOTICE! never Allow the Action to slAm closed by pressing the

bolt releAse button without the bArrel instAlled. if the bolt is

releAsed forwArd with the bArrel removed, the operAting

hAndle will strike the receiver And cAuse dAmAge.

2 Remove the forearm as explained previously.

NOTICE! do not squeeZe hArd on the open reAr end of A wood

foreArm. too much pressure could cAuse the wood to split.

3 For cleaning, remove the barrel and gas system by sliding

them forward and off the magazine tube. See “Cleaning and

Maintenance Suggestions” on page 35 for cleaning procedures.

For storage, remove the barrel and reinstall the forearm over the

magazine tube. You will then have two compact units: the barrel,

and the action with stock and forearm.

NOTICE! After the bArrel hAs been removed, leAve the bolt

in the reArwArd position. do not press the bolt releAse

button. if the bolt is releAsed forwArd with the bArrel

removed, the operAting hAndle will strike the receiver,

cAusing dAmAge.

AMMUNITION

use only shells of the correct gAuge And length. the gAuge

And length of the chAmber is inscribed on the side of the

bArrel. do not use Ammunition other thAn whAt is inscribed

on the side of the bArrel. exAmine every shell you put in your

shotgun. fAilure to follow this wArning could result in

serious injury or deAth And cAuse dAmAge to your shotgun.

use shells of the correct length. do not use 3" or 3½" shells

in A bArrel with A 2¾" chAmber, or 3½" shells in A bArrel with

6 Replace the forearm by sliding it onto the magazine tube and over

the gas bracket so it seats securely. Make sure the Speed Lock lever

is fully closed. It may be necessary to push rearward on the forearm

slightly to ensure the forearm is locked in place. When the forearm

is in place and the Speed Lock lever is fully locked, the release

button is flush with the surface of the forearm (Figure 9).

AlwAys ensure the foreArm is fully locked And the speed lock

lever releAse button is flush with the surfAce of the foreArm.

fAilure to follow this wArning could result in serious injury,

deAth or dAmAge to your fireArm.

DISASSEMBLY

AlwAys keep the muZZle pointed in A sAfe direction. before

stArting disAssembly procedures, open the Action And visuAlly

inspect the chAmber to be Absolutely certAin the fireArm is

completely unloAded. plAce the “sAfety” in the on sAfe

position. fAilure to follow this wArning could result in

serious injury or deAth.

figure 8

Slide the barrel and piston over the magazine

tube and the barrel extension into the receiver.

figure 9

Ensure the forearm is secured correctly, with

the button flush with the forearm, as shown in

the picture on the left.

08-121-BFA_Maxus OM.indd 14-15 6/22/09 2:59:57 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Comments to this Manuals

No comments

Maxus MXS21003 Owner's Manual Page 9

Comments to this Manuals